Introduction; Safety - LiftMaster Cloud CAP2D Manual Del Usuario

Ocultar thumbs Ver también para Cloud CAP2D:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INTRODUCTION

Safety

Safety Symbol and Signal Word Review
When you see these Safety Symbols and Signal Words on
the following pages, they will alert you to the possibility of
serious injury or death if you do not comply with the warnings
that accompany them. The hazard may come from something
mechanical or from electric shock. Read the warnings carefully.
When you see this Signal Word on the following pages, it will alert
you to the possibility of damage to your property or product if you
do not comply with the cautionary statements that accompany it.
Read them carefully.
To reduce the risk of SEVERE INJURY or DEATH:
• Disconnect power at the fuse box BEFORE proceeding.
• To AVOID damaging gas, power or other underground utility
lines, contact underground utility locating companies BEFORE
digging.
• ALL electrical connections MUST be made by a qualified
individual.
• ALL power and control wiring MUST be run in separate
conduit.
WARNING: This product can expose you to chemicals including lead, which are known to the State of California to cause cancer
or birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
UNDERWRITERS LABORATORIES (UL) COMPLIANCE
The CAP2D complies with the UL294 Standard for access control
units with the following restrictions:
The system relay contacts shall not be confi gured in the fail
secure mode unless permitted by the local authority having
jurisdiction and shall not interfere with the operation of panic
hardware.
The Ethernet port is for supplemental use only, the unit will
continue to operate standalone if the network connection is
interrupted.
This unit can be powered over Ethernet via PoE Compatible
hardware. Where used, any PoE power source must be UL294
Listed.
All interconnecting devices must be UL Listed.
PRE-INSTALL
WIRING
NETWORK
ACCESS CONTROL
To protect against fire and electrocution:
• Disconnect power BEFORE installing or servicing controller.
• NEVER connect a keypad/reader or lock to doors without first
consulting the applicable fire code.
• You MUST consult with, and get approval from, local fire
officials BEFORE installing locks or devices on ANY doors that
may be fire exits.
• Use of egress push buttons may not be legal. Single action
exits may be required.
• ALWAYS obtain proper permits and approvals in writing
BEFORE installing equipment.
DO NOT INSTALL THE SYSTEM IN THE FAIL SECURE MODE
UNLESS PERMITTED BY THE LOCAL AUTHORITY HAVING
JURISDICTION. Doing so may cause interference with the
operation of panic hardware.
3
INSTALL
MECHANICAL
ELECTRICAL

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido