Extension Cords - Beta 1852 R1750 Manual De Instrucciones

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
SAFETY RULES FOR USING DEVICE
Do not leave the induction heater BETA 1852 unattended when it is started. Always use the main switch to turn the device
BETA 1852 off if it is not used for heating!
Make sure that the power supply unit and the handle have an adequate supply of air for cooling. Make sure the vents are clean
and free of dust and dirt not to impede the flow of cooling air.
Do not attempt to repair the induction heater BETA 1852. The device does not contain any user-serviceable components, except
for replaceable heating coils.
Before connecting the device BETA 1852 to the wall outlet, make sure the outlet voltage corresponds to the voltage
on the rating plate. If the wall outlet voltage does not match the voltage indicated on the rating plate, it may result
in a serious risk of damage to the induction heater BETA 1852.
Do not exceed the operating cycle of the induction heater BETA 1852 – 2 minutes' heating (on) and 2 minutes'
cooling (off). The main equipment is protected against device overheating, but the heating coils are not, which may
cause them to be damaged.

EXTENSION CORDS:

Extension cords – if necessary, you may use only the following extension cords:
• up to 5 m with 2.5 mm
• up to 15 m with 4 mm
Use one extension cord – do not connect two or more extension cords. Do not use any extension cords other than those mentio-
ned above. Unpack the extension cords – tightly packed extension cords may overheat and cause fire.
GENERATORS:
When using the device with an alternate source of power – e.g. with a mobile electric generator -, a quality source of sufficient
power and AVR control must be used. Use a generator with a power output of at least 3-4 kW, or a DC/AC inverter with a power
output of 2-3 kW, and only with a sine wave – do not use the inverter with a square or quasi-sine wave. Failure to comply with the
above requirements may result in damage to the device and void the warranty.
The device must be protected from rain and moisture, mechanical damage and possible ventilation of neighbouring machines,
excessive overloading and rough handling.
14
diameter
2
diameter.
2
EN I