Signaling Devices; Preparing For Programming - Motostar S500R Manual De Instrucciones

Signaling devices

PROGRAMMING DEVICE -

Preparing for programming

Manually hook up the door to the skid.
Power up the operator. After emitting a sound signal, the control board is ready for programming.
Remove the transparent panel to access the programming keys.
Memorizing (function 5) must always be the last phase of programming, otherwise the settings will not be saved.
In the case of errors, cut off and the power up again the mains power and reprogram.
Flashing light (contact rated for: 24 V - 25 W max).
It flashes during opening and closing.