Putting Into Operation - Beta 3065/40-20T Manual De Instrucciones

INSTRUCTIONS FOR USE
PACKAGING
- The body and other parts of the jack are packed in a three-ply corrugated cardboard box with pallet; the operating
DQG PDLQWHQDQFH PDQXDO SOXV WKH ZDUUDQW\ FHUWL¿FDWH LQ D IROGHU DUH DOVR LQVLGH WKH ER[
- The instruction "Keep upright" is clearly visible on the cardboard box containing the jack.
- Depending on the number of jacks shipped, pallets of different sizes are used.
- Either transpallets or forklift-trucks are used for handling.

PUTTING INTO OPERATION

ASSEMBLY
1.Take the handle, the jack and the extensions out of the cardboard box.
2. Loosen the two nuts from inside the chassis. DWG. 10
3. Loosen screw from the chassis and remove parts keeping them assembled.
4. Fit the handle (the air distributor must be facing the pistons) inserting the coupling in the groove , put the parts
removed previously into the hole of the handle, tighten screw and then tighten nut .
5. Connect the two air pipes between the jack and the handle with the quick couplings on the chassis respecting
the colour indication as showed on the sticker on the chassis itself. DWG. 11
CONNECTION TO THE COMPRESSED AIR SYSTEM
- Compressed air enters into the jack circuit through the quick coupling on the top of the manual lifting/descending
controls; it is therefore necessary to have a connecting pipe with a quick coupling compatible with that of the jack.
Check that the air supply pipe has a useful passage of at least 6 mm and it is not pinched or restricted anywhere.
DWG. 12
:25.,1* $,5 35(6685(    %$5
- Absolutely never put the following into the compressed air circuit: hydraulic or Vaseline oil, brake liquid, kerosene
or other liquids.
 ,QVWDOO D ¿OWHU GHKXPLGL¿HUOXEULFDWRU XQLW LQ WKH FRPSUHVVHG DLU V\VWHP
- If you want to lubricate the compressed air circuit use exclusively:
AGIP OSO 100; MOBIL DTE 27; ESSO TERESSO 100;
SHELL TELLUS 100; BP ENERGOL HP 100
8
EN