Gladiator GAJG36FDYG Instrucciones De Ensamblaje página 5

4a.
Install Shelves
P1
A
A. Middle pair of slots in cabinet side
IMPORTANT: Use the pair of slots located in the middle of the
cabinet sides to install a center shelf (P5ml). The magnet should
be on the left-hand side and facing out when installed, so that the
door closure will make contact with the shelf, and the door will
lock. The other two shelves may be installed where desired. The
shelves are supported by the metal slots on the cabinet sides.
Make sure that the shelf (P5ml) magnet is visible on the left-hand
side and facing out, as shown.
Place a shelf (P5ml) so that the two tabs in the shelf ends are
aligned with the pair of slots in the middle of the cabinet sides.
P2
P1
P5ml
P3
4b.
Install Shelves
B
A. Push down
B. Lift up
A. Cabinet slot
B. Shelf tab
Tilt the shelf so that one end is higher than the other, as shown.
Insert the shelf into the cabinet so that the higher end is directly
above the desired slots, and then push the shelf down into place
behind the side slots. Raise the lower end so it is directly above
the desired slots, and then push the shelf down.
NOTE: You may need to slightly bend the shelf tabs outward for
the tabs to engage in the slots. Make sure the shelf tabs are in
place behind all the slots, as shown.
A
A
B
5