Attach Back Panels; Important - Gladiator GAJG36FDYG Instrucciones De Ensamblaje

2.

Attach Back Panels

F3c Phillips-head screw (34)
AAA
P1
DDD
EEE
P1
P3
IMPORTANT: Attach the back panels starting at the top of the
cabinet with back panel (AAA) and working down to the cabinet
bottom. Each back panel will overlap the panel below. Do not
completely tighten the screws until all back panels are in place.
Align back panel (AAA) with the holes in the cabinet top. Using
Phillips-head screws (F3c), attach back panel (AAA) to the cabinet
top and sides. Slide the top of back panel (BBB) under the bottom
of back panel (AAA). Using Phillips-head screws, fasten back
panel (BBB) to the cabinet sides. Repeat Step 2 for the remaining
back panels ending with back panel (EEE). Using Phillips-head
screws, attach each back panel to the panel below.
NOTE: Using Phillips-head screws, attach panel (EEE) to the
cabinet bottom (P3).
Completely tighten all back panel screws starting with the sides
and continuing with the top, middle and bottom. Using the hex
key (provided), completely tighten all cabinet bolts and nuts.
4
F3c
AAA
BBB
CCC
P2
P1
3.
Install Leveling Legs (optional)
Leveling feet (4)
P1
A. Leveling legs
IMPORTANT: If you are going to install the cabinet on Gladiator
GearWall panels or GearTrack
®
install leveling legs.
Place the cabinet on its side. Screw a leveling leg (P4) into each
of the four rivet nuts located at the corners of the cabinet, as
shown. Stand the cabinet upright. If you have not already done
so, fasten the two bolts at each front corner of the cabinet frame.
Completely tighten all of the cabinet bolts and nuts.
P4
P4
P3
A
channels, you do not need to
®
®