ProKlima 26507950 Manual De Instrucciones página 63

4
Figure
Elongate the exhaust pipe and snap the flat end of the exhaust pipe joints into the hole of the
window sealing
plate assembly (as shown in Fig.5 and Fig.6) .
Notes ： 1 、 the flat end of the exhaust pipe joints must be snapped into place.
2 、 The pipe cannot be distorted nor has substantial turning (greater than 45 ° ).
Keep the ventilation of the exhaust pipe not blocked.
5
Figure
6
Figure
Important Notice:
The length of the exhaust hose shall be 280~1,500mm, and this length is based on the
63