Tabla de contenido
Publicidad
Encabezado/Comando
COM.NOHEADERS-
MODE=
TCPn.ENABLE=
TCPn.ECHO=
TCPn.REPLY=
TCPn.PORT=
UDPn.ENABLE=
UDPn.ECHO=
UDPn.REPLY=
UDPn.PORT=
UDPn.GROUP=
WHITELIST.ENABLE=
WHITELIST.IPn=
ALARMS.DPS.ENABLE=
ALARMS.DPS.TIMEON=
ALARMS.RT.ENABLE=
ALARMS.RT.TIMEON=
ALARMS.PILOT.ENABLE=
ALARMS.PILOT.TIMEON=
ALARMS.PI-
LOT.TIMEOFF=
ALARMS.LOGEMAIL=
Parámetro
This defines how text is used if no headers are required.
COM Port No
0 = Text to DPS.
Headers Mode
1 = Text to RT.
2 = Text to both DPS & RT.
0 = TCP port disabled.
TCP Enable
1 = TCP port enabled.
Echo defines whether all data received by the port is trans-
mitted back to the sender.
TCP Echo
0 = Echo disabled.
1 = Echo enabled.
Reply defines whether OK or NO is transmitted to the
sender after the receipt of a valid/invalid command.
TCP Reply
0 = Reply disabled.
1 = Reply enabled.
TCP Port
Sets the TCP port to receive data.
0 = UDP port disabled.
UDP Enable
1 = UDP port enabled.
Echo defines whether all data received by the port is trans-
mitted back to the sender.
UDP Echo
0 = Echo disabled.
1 = Echo enabled.
Reply defines whether OK or NO is transmitted to the
sender after the receipt of a valid/invalid command.
UDP Reply
0 = Reply disabled.
1 = Reply enabled.
UDP Port
Sets the UDP port to receive data.
Sets a UDP multicast group to join for receiving multicast
UDP Multicast
data.
Group
0.0.0.0 disables multicast for this port.
0 = IP whitelist disabled.
Whitelist Enable
1 = IP whitelist enabled.
Whitelist IP Ad-
Sets IP addresses from which data will be accepted. Data
dress
received from any other IPs will be rejected.
DPS Update
0 = DPS update alarm disabled.
Alarm Enable
1 = DPS update alarm enabled.
DPS Update
1-240 = The number of minutes between receipt of the last
Alarm Time On
DPS message and triggering of this alarm.
RT Update Alarm
0 = RT update alarm disabled.
Enable
1 = RT update alarm enabled.
RT Update Alarm
1-240 = The number of minutes between receipt of the last
Time On
RT message and triggering of this alarm.
Pilot Loss Alarm
0 = Pilot loss alarm disabled.
Enable
1 = Pilot loss alarm enabled.
Pilot Loss Alarm
1-240 = The number of seconds between loss of pilot and
Time On
setting this alarm.
Pilot Loss Alarm
1-240 = The number of seconds between recovery of pilot
Time Off
and clearing this alarm.
1-100 = The percent fullness of the alarm log at which an
Alarm Log Email
email will be sent as a reminder about the alarm log full-
Threshold
ness.
— 56 —
Detalles
Publicidad
Tabla de contenido
