Orima ORD-651 Manual De Instrucciones página 9

Electrical Connection and Security
1. THIS APPLIANCE MUST BE EARTHED
2. Your oven is adjusted in compliance with 230-240 Volt AC, 50 Hz (for SA will be 220-240V,60 Hz), electrical
supply, and requires a 16 Amp (for England 13 Amp) fuse. If the mains are different from this specified value,
contact an electrician or your authorised service.
3. Isolation switches for the oven must be accessible to the end user with the oven in place.
4. Should you need to replace the 16 Amp plug top (for England 13 Amp), please ensure you rewire the plug as
follows; Brown wire to the Live terminal
5. Electrical connection of the oven should only be made by using sockets with Earth system installed (for England
B.S. Approved sockets with Earth system), and in compliance with Regulations. If there is no proper socket with
Earth in place, immediately contact a qualified electrician. The Manufacturer will not be responsible for damage
or injuries that can arise because of inappropriate supply outlets with no earth system.
6. If your electric supply cable becomes damaged, it should be replaced by an authorised service engineer or
qualified electrician.
7. The electrical supply cable should not touch the hot parts of the appliance.
8. The oven should be installed into an oven housing that provides good higher ventilation.
9. This oven must be correctly installed and secured in place, in accordance with manufacturer's instructions and
by a qualified person.
10. Never work on the oven while it is switched on. Maintenance and service must be carried out after the power
supply has been disconnected.
Important notices for the installation;
1. This appliance must be installed by a competent person and with particular attention to ventilation
2. The housing must be heat resistant to a temperature of 95 °C as per EEC directives.
3. The oven can be installed into a Standard 600 mm housing unit as shown in Figure-1, or in a tall housing unit
when built-in a column.
4. In both cases ventilation provisions must be made. Keep a gap at the back of the housing unit of 85 - 90 mm
depth.
5. Do not step-on, lean-on or rest heavy items on the open door, or maneuvers the oven by the door.
INSTALLATION OF YOUR OVEN
Blue wire to the Neutral terminal
Yellow & Green wire to Earth
60 cm
Figure-1