Aiwa NSX-A999 Manual De Instrucciones página 22

6 Press REC/REC MUTE to start recording on
I
MULTI
,JTfi...
tie
.
The Al edit recording function enables CD recording without
worrying about tape length and track length. When a CD is
inserted, the unit automatically calculates the total track length,
If necessary, the order of tracks is rearranged so that no track is
cut short.
(Al: Artificial Intelligence)
m
Al edit recording will not start from a point halfway into the tape,
The tape must be recorded from the beginning of either side.
1
2
3
4
5
Insert the tape into deck 2, and press DOLBY NR
to turn Dolby NR on or off.
Insert the tape with the side to be recorded on first facing out
from the unit.
Press CD and load the disc(s).
Press CD EDIT/CHECK ~.
"EDIT" is displayed.
EDIT
QWhen "PRGM" is displayed, press CD EDIT/CHECK.
Press
DISC DIRECT PLAY 1-3 to select a disc.
Press numbered buttons O-9 on the remote
control to designate the tape length.
10 to 99 minutes can be specified.
Example: When using a 60-minute tape, press 6 and O.
In a few seconds, the tracks to be recorded on each side 01
the tape are determined.
+", - or MULTI
the tape length.
Tape length
JOG are also available to designate
Programmed
Remaining time tracks for
of recording side A
the first side.
The tape is rewound to the beginning of the front side, the
lead segment is played through for 10 seconds, and recording
starts. When recording on the front (side A) ends, recording
on the back (side B) starts.
To stop recording
Press . Recording and CD play stop simultaneously.
To clear the edit program
Press CLEAR twice so that '(EDIT" disappears on the display.
To
check the order of the programmed track numbers
Before recording, press CD EDIT/CHECK to select side A or B,
and press + or - repeatedly.
Programmed
Track number
track numbers
Tape Aide Program number
To add tracks from other discs to the edit program
If there is any time remaining on the tape after step 5, you can
add tracks from other discs in the CD compartment .
1 Press CD EDIT/CHECK to select side A or B.
2 Press DISC DIRECT PLAY 1-3 to select a disc.
3 Press numbered buttons on the remote control to select tracks.
A track whose playing time is longer than the remaining time
cannot be programmed.
4 Repeat steps 2 and 3 to add more tracks.
Time on cassette tapes and editing time
The actual cassette recording time is usually a little longer than
the specified recording time printed on the label. This unit can
program tracks to use the extra time. When the total recording
time is a little longer than the tape's specified recording time
after editing, the display shows the extra time (without a minus
mark), instead of the time remaining on the tape (with the minus
mark).
The Al edit recording function cannot be used with discs
containing 31 tracks or more. "TR OVER is displayed if this is
attempted.
QRecording is inhibited if the erasure prevention tab on either
side of the tape is broken off.
Tape side
A: First recording side
B: Second recording side
22
ENGLISH