Recommended grounding method
A 110 V or 220 V (see freezer plate), 50 Hz or 60 Hz, AC
only, 20 A or 15 A, respectively, fused or circuit breaker,
grounded electrical supply is required. It is recommended
that a separate circuit serving only your freezer be
provided. Use an outlet that cannot be turned off by a
switch. Do not use an extension cord.
NOTE: Before performing any type of installation or cleaning,
disconnect freezer from the electrical source.
Voltage variation
Product voltage
110 V
220 V
How to operate the temperature control
Your product can work either as a freezer or refrigerator.
Set the temperature control according to your needs.
The control leaves
factory set to freezer
mode, that is, to freeze
food.
Internal temperature
is set by turning the
control to the
position you wish.
Freezer Mode
Use
Temperature
Position
6 or 7
To freeze food
-18 °C a -25 °C
Position
4 or 5
Voltage limit
98 V to 140 V
198 V to 242 V
Using the freezer
Models:
WHA14ABDWC,
WHA20ABDWC
and WHA30ABDWC
Conditions of use
Hot days
A lot of food
stored
Cold days
Not much food
stored
Defrosting drain plug
1. Remove drain plug from packaging.
2. Place drain plug into drain hole as shown in the
figure.
NOTE: In models WHA14ABTWW and for all WHA20,
the drain is located in the front part of the product.
In models WHA30 and WHA14ABDWC, it is located in
the back.
Refrigerator Mode
Use
Temperature
Position 3
To cool and
preserve foods
and drinks
+1 °C a +5 °C
Position
1 or 2
Important:
Refrigerator/
Cooler
This temperature
setting should be used
to cool food and drinks.
Do not use the intermediary setting, because your product will
neither reach the ideal temperature to cool nor to freeze the food.
14
Conditions of use
Hot days
A lot of food
stored
Cold days
Not much food
stored
Freezer Setting
This temperature setting should
be used for freezing food. It is
not advisable
to use with beverages.