Atlantic SOL Lighting SOLCC2 Manual De Instrucciones página 5

• To switch to the Preset Light Changing Modes: hold the B button for three
seconds or until the light changes to Crystal White. Press the D button, and the
light will return to the last preset mode displayed while in the Light Changing
Modes. Press the D and E button to switch between the different preset modes.
Changing the Brightness and Speed
In all modes, you can use the E and F keys to change the brightness of the light.
In all modes, you can use the G and H keys to change the speed of the light
transitions. There are 10 levels for each.
Synchronizing the Remote to the Control Unit
If the remote control stops working properly, please install fresh batteries. If
problems persist, the remote may need to be re-synced to the control module.
Follow the instructions below to re-sync the remote control.
1. Unplug the transformer.
2. Hold the E button down (The red indicator lamp on the remote will be lit).
3. While still holding the E button down, plug in the transformer. The Colorfalls will
start blinking.
• If the Colorfalls blinks three times and stops, the remote and control unit
are synchronized.
• If the Colorfalls blinks six or more times, it is clearing all codes. Repeat steps
1-3.
Maintenance
Replacement LED Bulbs are available for SOL Color Changing Spotlights and
Compact Spotlights. To loosen and tighten the brass lens ring on SOL Color
Changing Spotlights and Compact Spotlights, use the included key. Simply place
the key in the slots on the brass lens ring to loosen or tighten. Ensure that all
components are installed correctly after servicing. Inspect the silicone gaskets for
defects and proper placement before re-assembling. Ensure that the lens ring is
tightly secured before submersing the fixture.
SOLCC2:
Brass Body
Brass Lens Ring
Disc Lamp Gasket Lens Slot
5