Safety Rules; Sweeping And Maintenance Recommendations For The Appliance And Smoke Flue; Removal Of The Deflector; Removal Of The Draught Damper - deville C07836 Instrucciones Para Instalación Y Empleo

6.4.2.4 Safety Rules

- Never try to extinguish the fire with water.
- Be careful of the glass, which gets very hot. Keep children away from it.
- The insert gives out a lot of heat through the glass, so keep materials and heat-sensitive objects at least
1.50 metres away from it.
- Empty the ashpan into a special metal or otherwise inflammable receptacle used only for this purpose.
Ashes that might appear cold can still be very hot, even if you think they have had enough time to get
cold.
- Do not put easily flammable materials near the appliance.
- In case of chimney fire, put the thermostat on position 0 and close the draught damper (pipe key).
7- SWEEPING AND MAINTENANCE RECOMMENDATIONS : INSERT AND SMOKE FLUE
Mechanical sweeping of the smoke flue is obligatory. This should be done several times a year and at least once during
the heating period. The contractor concerned should provide the necessary certificates.
For sweeping :
Remove the deflector and the draught damper (pipe key) and put them back into place after sweeping (see
-
instructions hereafter).
Carefully check the condition of the appliance, and more especially smoketightness : seals, fixings, door and
-
frame.
Check the condition of the smoke flue and the connecting pipe ; all fittings should be in good mechanical
-
condition and smoke-tight.
Using the vacuum cleaner, clean the inside of the hood to get rid of any dust and if necessary clear the hot air
-
convection system (air inlet and outlet through the hot air supplying ducts) and fresh air inlet.
In case of problems, have your appliance or installation checked and repaired by a tradesman.
Clean the glasses with a damp cloth and ash ; if necessary, use a household cleaning product (soda products)
following the user instructions. Wait until the appliance is completely cold before cleaning.

7.1 - REMOVAL OF THE DEFLECTOR

The deflector (Fig. 18) with notches (E) at the front (F) sides leans :
- at the back : on the square
- on the sides : on the lugs (P)
- lift the front of the deflector and pull towards oneself to release the deflector from the rear square
- release the lug (Fig. 20).
- take out the deflector through the front of the appliance (Fig. 21).
To replace the deflector
- follow the same steps in reverse.

7.2 - REMOVAL OF THE DRAUGHT DAMPER

Once the deflector removed, loosen the screw (A) (use box spanner H 10) ; release the knob and the control stem
partially, without drawing them out of the grille, in order to release the flap (Fig. 22).
Nota : Set the knob in vertical position to make it easier for the pin to go through the grille.
To replace the draught damper
Follow the same steps in reverse. See to the right orientation of the key (vertical key for vertical flap).
26
(Fig. 19).