Rocal RCr Manual De Caracteristicas, Instalacion Y Funcionamiento página 15

1.6.2. Room Ventilation.
place the appliance so that it cannot be blocked, and the simultaneous operation with other ventilation
devices and / or heat such as exhaust fans (kitchen, bathroom, etc.), heat pump, etc... In these cases
must be compensated extraction with the entry of outside air.
1.7. Fireplace Room. It must be built with non-flammable material and should not be sitting on top of
the apparatus. In reference to the contact points (front frame. Neither flammable nor fragi le material
can be contained inside (wood, paper wall, glass, chalk...).
1.8.Possible appliance adjustments. It is possible that the installation, the appliance is
adjusted, if so, the following steps:
1.8.1. Door closing mechanism graduate (D-5). This adjustment mechanism for adjusting screw cap
closure mechanism of the door, that is a part located on the module.
1.8.2. Graduate hinges mechanism (D-6). The door hinges can also be graduating and thus set
about closing the door to tighten or loosen this screw hinge.
1.8.3. Frame adjustment (D-7, D-8). Unscrew the 4 screws on the frame, fit the frame and tighten
again.
1.9. Inside the appliance (D-9).
Inside of the appliance is coated with vermiculite plates. These are placed direct, but can be
disassembled for easy transport and positioning of the insert or for possible replacements.
1.9.1. Side pieces (D-10). Remove the vermiculite side pieces
1.9.2. Baffle plate (D-11). The baffle plate pieces are engaged with each other and fix with a metallic
support. Pull out this set ensuring that the vermiculite pieces not fall.
Warning:
When replacing the baffle plate must ensure that the pieces fit correctly (D-13)
1.9.3. Back pieces (D-14). Remove one by one the pieces of vermiculite from the bottom.
WARNING:
It is important to ensure that these vermiculite pieces NO RECEIVING KNOCKS.
1.10. Cleaning and maintenance. It is highly recommended an accessible zone for the cleaning of the
apparatus, smoke chamber and smokestack.
2. USER'S GUIDE
ALL LOCAL, NATIONAL
WHENINSTALLING THE APPLIANCE AND USED FUELS.
Warning: Do not operate or handle any part when the fireplace is working unless using the
exothermic glove.
2.1. Using for the first time.
as specified in the table of Technical characteristics must be respected.
WARNING:
You must respect the maximum load allowed by the manufacturer of the
logs as well as the height of the recharge.
2.2. Fire control. To obtain the correct performance, adjust the position show the following table I:
Technical characteristics.
It should take into account a sufficient outside air to the room where we will
AND EUROPEAN STANDARDS
For early on, and for a reasonable time, the data on the maximum load
MUST BE COMPLIED WITH
Pag. 14