Publicidad
Idiomas disponibles
Idiomas disponibles
Heating Cable Types
Insulated bus wire
VPL-CT
1
• Allow approximately 24 in (60 cm) of heating cable for
installation. For VPL, cut cable 12 in (30 cm) from bus
indentation.
• Cut off heating cable end at about 45° for easier insertion.
24w
(60 cm)
3
• Determine heating cable type and continue as shown.
VPL
BTV and QTVR
XTV and KTV
INDUSTRIAL HEAT TRACING SOLUTIONS
Braid
Inner jacket
Heating element
Bus wire connection
Clear jacket
BTV-CR, BTV-CT, QTVR-CT
12 in
45°
(30 cm)
Indentation (bus wire
connection on VPL
heating cables only).
Go to Step 4A
Go to Step 4B
Go to Step 4B
EN-RaychemE100Aendseal-IM-H55400 02/15
Outer
jacket
Braid
Inner jacket
Conductive core
Bus wire
2
• Optional: If stand is to be
installed on bottom side of
pipe, knock out drain hole
prior to inserting cable.
• Push 12 in (30 cm) of
heating cable through
stand. Use cable lubricant
if needed.
• Square off cable end with
90° cut.
Outer
jacket
Conductive fiber
Spacer
Bus wire
XTV-CT, KTV-CT
Outer
jacket
Braid
Inner jacket
12 in
(30 cm)
Drain hole
• Do not attach
stand to pipe
until step 8.
2 / 6
Publicidad
