Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
en
ENGLISH
12. Accessories
Use only genuine Metabo accessories.
Use only accessories that fulfil the requirements
and specifications listed in these operating
instructions.
For a complete range of accessories, see
www.metabo.com or the catalogue.
13. Repairs
Repairs to electrical tools must be carried out
by qualified electricians ONLY!
If you have Metabo electrical tools that require
repairs, please contact your Metabo service centre.
For addresses see www.metabo.com.
You can download spare parts lists from
www.metabo.com.
14. Environmental Protection
The sanding dust generated may contain
hazardous materials: do not dispose of with the
household waste, but at a special collection point
for hazardous waste.
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
To protect the environment, do not dispose of
power tools with household waste. Observe
national regulations on separated collection
and recycling of disused machines, packaging and
accessories.
15. Technical specifications
Explanation of details on page 3. Subject to change
in line with technical advances.
D
= max. diameter of accessory
max
t
= Max. permitted thickness of clamping
max,1
shank on accessory when using
clamping nut (10)
M
= Spindle thread
l
= Length of the grinding spindle
n*
= No-load speed (maximum speed)
P
= Nominal power input
1
P
= Power output
2
m
= Weight without mains cable
Measured values determined in conformity with
EN 60745.
Machine in protection class II
~
Alternating current
* Energy-rich, high-frequency interference can
cause fluctuations in speed. However, the
fluctuations disappear as soon as the interference
fades away.
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
14
Using these values, you can estimate the emissions
from this power tool and compare these with the
values emitted by other power tools. The actual
values may be higher or lower, depending on the
particular application and the condition of the tool or
power tool. In estimating the values, you should
also include work breaks and periods of low use.
Based on the estimated emission values, specify
protective measures for the user - for example, any
organisational steps that must be put in place.
Vibration total value (vector sum of three directions)
determined in accordance with EN 60745:
a
= Vibration emission level
hV
(grinding)
K
= Uncertainty (vibration)
h,...
Typical A-effective perceived sound levels::
L
= Sound pressure level
pA
L
= Acoustic power level
WA
K
, K
= Uncertainty
pA
WA
During operation the noise level can exceed
80 dB(A).
Wear ear protectors!
Publicidad
Tabla de contenido
