Power Source; Troubleshooting Guide; Specifications - Bigben Interactive TW10 Modo De Empleo

4. On your Bluetooth device, turn Bluetooth functionality on. Typically, Bluetooth controls are found
on the device's tools or settings menu (see your user manual). Turn Bluetooth connectivity on and
make your device 'discoverable'.
5. Clean out the pairing list on your Bluetooth device.
6. Choose 'add a new Bluetooth device' or 'set up Bluetooth device' on your device. It will start to
search. Once "TW10" shows on your device, select it. If your device prompts you for a pass code,
please enter 0000. If the pairing attempt fails or times out, please start the pairing procedure again
(see steps 2-6).
7. After your device and the "TW10" have connected to each other, a sound can be heard.
Play MUSIC from Bluetooth devices.
Make sure the Bluetooth connection between the unit and the device is active.
1. Press the button to pause playback, and press the
2. Press the button to skip forward to the next track and the
previous track.

Troubleshooting guide

Symptom
No power
No sound
Sound distortion
Bluetooth reception
failure

Specifications

Power source:

Radio Coverage:
Impedance of Speakers:
Loudspeakers
Subwoofer
Bluetooth working distance:
Remote working distance:
Light source:
Cause
AC plug not plugged into wall outlet.
Volume set too low.
The connected device is not in
playback mode.
Sound output of the connected device
set too low (AUXIN & BLUETOOTH
mode)
Volume level too high
Volume level of the connected device
too high.
(AUX IN & BLUETOOTH mode)
Not properly connected via Bluetooth.
AC 230V- 50Hz
FM 87.5 -108.0 MHz
8 ohm, 10W x 2
8 ohm--20w
up to 10 metres measured in open space. (Walls and structures may
affect device range)
up to 5 metres
Astro: 3xRGB LEDs of 3W; UFO: 48x10MM RGB LEDs
button again to resume playback.
Solution
Plug it into the wall outlet properly.
Adjust volume to a desired level.
Play the music in the connected
device.
Adjust volume of connected
device.
Reduce the volume level by
pressing the VOL- button.
Reduce the volume level of the
connected device.
Check that Bluetooth is activated
on your device and retry Bluetooth
connection (see page 6).
- EN 7 -
button to skip backward to the