Transmitting Stored Data; Setting Date And Time - Xylem YSI 910 COD Manual De Instrucciones

Store Date
Prt note: to print data, or to transmit to a PC, the optional Series 900 Data Hub (Inf-
1
rared Interface Module) is required.
Time Cal
the Series 900 Data Hub and the connected printer/PC must be ready. Press
the [MODE] key to start the transmitting, the instrument displays "PrtG" (Printing)
for approx. 1 second followed by the number of the first data set and its transmis-
sion. All data sets will be transmitted one after the other. After finishing the instru-
ment returns to test mode.
The print job can be cancelled by pressing the [On/Off] key. The instrument turns
PrtG
off.
On
Off
If the instrument is not able to communicate with the IRiM, a timeout occurs after
approx. 2 minutes. The error E 132 is displayed for approx. 4 seconds. Subse-
quently, the instrument returns to test mode (see also IriM manual).
E 132
Store Date
2
3
After confirming the selection with the [MODE] key the value to be edited will be
Time Cal
shown for 2 sec.
Mode
The setting starts with the year (YYYY) followed by the actual value to be edited.
The same applies for month (mm), day (dd), hour (hh) and minutes (mm). Set the
minutes first in steps of 10, press the [!] key to continue setting the minutes in
SET
steps of 1.
DATE
YYYY
(2 sec.)
Increase the value by pressing the [MODE] key.
Mode
Decrease the value by pressing [ZERO/TEST] key.
Zero
Test
Proceed to the next value to be edited by pressing [!] key.
!
After setting the minutes and pressing the [!] key the display will show "IS SET"
and the instrument returns to the measurement mode.
prt – transmitting stored data (to printer or pC)
1
setting date and time (24-hour-format)
2
englIsH
9