Mosa GE 7000 Manual De Instrucciones página 51

© MOSA REV.1-09/06
BATTERY WITHOUT MAINTENANCE
Connect the cable + (positive)
to the pole + (positive) of the
battery (after having taken
away the protection), by
properly tightening the clamp.
Check the state of the battery
from the colour of the warning light which is in the
upper part.
- Green colour: battery OK
- Black colour: battery to be recharged
- White colour: battery to be replaced
DO NOT OPEN THE BATTERY.
LUBRICANT
Check the level of the engine oil using the
ASTINA LIVELLO
OLIO
(appropriate oil dipstick: the level should
MAX
LIVELLO
be between the minimum and maximum
OPERATIVO
MIN
marks.
lf necessary, add more oil through the appropriate
inlet
Fill the air filter using the same oil up to the level
indicated on the filter (machine with oil bath air
filter).
OIL RECOMMENDED
MOSA advises to choose AGIP for the type of oil.
Please keep to the label put on the engine for the
recommended products.
☞
NOTE: before starting and switching off, see
instructions in the engine owner's manual
herewith attached.
SETTING-UP THE UNIT (GASOLINE ENGINES) GE_, MS_, TS_
FUEL
Check the level of fuel in the tank and, if necessary,
add more standard gasoline of any type you can
buy (e.g. 84-96 ON).
If during the filling of the tank some
gasoline is accidentally spilled around
the engine chassis, clean it immediately
before starting up the engine.
ENGINE WITH OIL ALERT DEVICE
The OIL ALERT device will stop the engine in case
of no oil or insufficient amount of oil in the engine.
In case one tries to start the engine with oil below
the minimum level, the warning light (when
assembled) will light and the device will not allow
starting.
CLEANING OF DRY AIR FILTER
See page M43.
GROUND CONNECTION
☞
lt is obligatory to connect the ground
connection point (12) by means of a sure
efficient cable (please follow the installation local
rules and/or regulations in force) in order to
integrate or ensure the working of various
electric protection devices referring to the
several distribution systems TN.
The unit can be started only when the above
operations have been correctly performed.
M
25