Operating The Lamp Tester - Beha-Amprobe LT-10 Manual De Instrucciones

2. Verify if voltage is present at the ballast with VolTect
voltage detection.
3. If light bulb passes the test in step 1 and the voltage is present in step 2,
but the lamp is not working, then replace the ballast.
Features:
• Tests fluorescent (electroluminescent) lights
• Built-in VolTect™ non-contact voltage detection
• Lamp and filament test to check fluorescent and sodium light bulbs
• Simple one-handed, single button operation
• Ultra-compact design for portability
• 48" removable, fully retractable antenna included to test lights and
voltage without a ladder
• Compatible with light bulbs:
- Fluorescent T2, T4, T5, T8, T9, T10, T12 light bulbs
- Fluorescent energy saving light bulbs
- Low pressure sodium vapor bulbs
- High prossure sodium vapor bulbs
- Neon bulbs
- Mercury vapor bulbs
- Halogen metal vapor bulbs
• Insulated antenna sleeve and tip provided to safely extend and
retract during use
• Does not work with LED and incandescent (standard) light bulbs
• Replacement parts: Antenna LT-10-ANT (Item No. 4357839)
OPERATING THE TESTER
The test probe and antennas emit a high frequency voltage (approximately
3 kV) to ionize the light fixtures in order to diagnose a failure.
W Precautions:
• To avoid electric shock, do not touch ANY part of antenna during lamp
or voltage tests. Touching antenna during these tests affects tester
sensitivity.
• When LAMP TEST button is pressed, be alert. Do not touch test probe
or antenna. Discharge can cause electric shock or personal injury.
• Do not attempt to overreach. Make sure you have proper footing and
balance at all times.
5
non-contact
™