Operating Messages; Error Codes; Instrument Accessories Information - Orbeco SC450 Manual De Instrucciones

Operating messages – Error codes
Hı
Lo
btLo
Store Date
Print Time
Cal
RESULT
E27 / E28 / E29
E 10 / E 11
E 20 /E 21
E23 / E24 / E25
E 22
E 70
E 71
E 72
E 73
SC450_V1_11.2010

Operating messages

Measuring range exceeded or excessive turbidity.
Result below the lowest limit of the measuring range.
Replace batteries, no further tests possible.
Battery capacity is too low for the display backlight;
measurement is still possible.
A user calibrated method is indicated by a "Cal" symbol while the test
result is displayed. (see "Factory calibration reset").

Error codes

Light absorption too great. Reasons: e.g. dirty optics.
Calibration factor "out of range"
Too much light reaching the detector.
Too much light reaching the detector.
Battery capacity was too low during measurement. Change battery.
CL 2: Factory calibration incorrect / erased
CL 2: User calibration incorrect / erased
CL 8: Factory calibration incorrect / erased
CL 8: User calibration incorrect / erased
Instrument accessory information
IRiM
24 mm Sample Cells, 12 pack
10 mm Multi-Vials, type 2, 12 pack
Light shielding rings
Cleaning cloth for sample cells
Sample cell rack
EZ Mix Primary Chlorine Standard Kit
Secondary Reference Standard Kit
MC500-60
L197620
L197600
L197626
L197635
9999
ST100-10
L275660
17