Tape Counter Memory Feature; Additional Information - Magnavox MDV560VR Guia Del Usuario

26 Operation

Tape Counter Memory Feature

Real-Time Counter
Shows length of tape run in hours, minutes, and seconds.
Press DISPLAY to select the real-time counter display.
Every press of DISPLAY changes the TV screen as
shown below.
2:15 AM
CLOCK COUNTER
" Counter changes to "0:00:00" when the cassette is
ejected.
" The real-time counter does not operate if nothing is recorded
on the tape.
" The real-time counter will not work unless a tape is
inserted.
Counter Memory Function
This is useful if there is a section of tape you want to view
immediately after recording or if you want to return to the
same point several times.
1 1
Begin recording or playing a tape.
2 2
Press DISPLAY repeatedly to display the real-
time counter on the TV screen.
3 3
At the point you want to locate later, reset the
real-time counter to "0:00:00" by pressing
CLEAR.
4 4
Continue to play or record.
5 5
Press STOP (x x ) when recording or playback fin-
ishes.
6 6
Press . . .
The tape automatically stops when the tape counter
returns to about "0:00:00".
Tape Remaining
This function allows the time of the remaining tape to be dis-
played during recording or playback.
Press DISPLAY until the REM indicator displays on the TV
screen during recording or playback.
Note
The remaining tape length indicator may not be displayed
correctly depending on the condition of the tape and the kind of the
tape (T-140, T-160, or T-210 etc.).
0:05:25 REM 1:07
REMAINING TIME

Additional Information

" In manual recording, Timer recording, Instant Timer Recording,
playback, or fast forward modes, the DVD+VCR automatically
starts rewinding the tape at the end of the tape. The cassette will
stop at the beginning of the tape and be ejected, and the
DVD+VCR will turn itself off (Functions only with no disc in
unit).
" After you have finished using the DVD+VCR, rewind, eject, and
remove the cassette. Place the cassette in its protective sleeve to
protect it from dust. It is not necessary to rewind the cassette
before removing it, but if you do, it will be ready to play or
record the next time you use it.
"
Be sure the DVD+VCR Channel Selector is on the correct chan-
nel you wish to record. The channel that is being recorded can
always be checked by setting the television on the DVD+VCR
channel (3 or 4) and pressing the TV/VCR selector to turn off
the DVD+VCR's TV indicator.
" Do not attempt to hook up more than one television set to the
DVD+VCR for either recording or playback.
Auto Play System
This DVD+VCR features automatic playback.
Load a cassette (with the safety tab removed).
" The Output Source is changed to VCR mode automatically.
" The power turns on automatically and playback begins.
" At the end of the tape, the DVD+VCR stops, then rewinds.
" The cassette is ejected after rewinding and the unit turns itself
off automatically.
Note
Auto power off does not function during regular DVD play mode.
(DVD+VCR power stays on.)