Wolf ICBSRT304 Guia De Instalacion página 5

I NSTAL L AT IO N
Preparation
Prepare the finished opening for the rangetop according
to the dimensions shown in the installation illustration. The
platform must include a cutout at the right rear for the elec-
trical and gas supply connections. It must be level to ensure
the cooking surface is level. Refer to the chart below for the
minimum base support.
IN S TA LL AT I O N R E Q U IR E M E NT S
PLATFORM
Thickness
BA SE S UP P O RT
762 mm Rangetop
914 mm Rangetop
1219 mm Rangetop
Placement
Use an appliance dolly to move the unit near the opening.
Remove and recycle packing materials.
If a riser is specified, refer to the installation instructions
packaged with the riser. The riser must be installed before
the rangetop is installed.
Place the unit into the opening. Connect the gas and elec-
trical supply. Connections may need to be made prior to
final placement.
Gas Supply Connection
All connections to the gas piping must be wrench-tightened.
Do not overtighten or allow pipes to turn when tightening.
If a flexible metal connector is used, verify it is not kinked,
then attach the gas supply line to the regulator on the
rangetop. Open the valve and check for leaks by placing
a liquid detergent solution onto all gas connections.
Bubbles around the connections indicate a gas leak. If
a leak appears, close the shut-off valve and adjust the
connections.
19 mm
M I N
91 kg
113 kg
136 kg
TRO U BL E S HO O T ING
Troubleshooting
IMPORTANT NOTE: If the rangetop does not operate prop-
erly, follow these troubleshooting steps:
• Verify electrical power is supplied to the rangetop.
• Verify the gas supply shut-off valve is in the open
position.
• If the rangetop does not operate properly, contact Wolf
Factory Certified Service. Do not attempt to repair the
rangetop. Wolf is not responsible for service required to
correct a faulty installation.
|
wolfappliance.com 5