Connect Power - GE PCR06BATSS Manual De Instrucciones

LEVEL
3
• Use an adjustable wrench to turn the leveling
legs and raise or lower the product.
• Adjust carefully; the product should be level
and plumb with cabinetry, and should align with
adjacent toekick height.
Turn Right to Lower
Turn Left to Raise
If you skipped Step 2:
• Select the hinge cover marked "R" or "L",
depending on door swing.
• Peel backing off the tape inside the decorative
hinge cover. Press and snap into position.
49-60466-3
Installation Instructions

CONNECT POWER

4
• Connect power cord plug to a properly grounded
receptacle.
• Make sure power is on by opening the door to
see if interior light turns on.
SLIDE PRODUCT INTO THE
5
CUTOUT
• Carefully slide the unit into the opening. Be
careful not to entangle power cord.
• Make certain that the door protrudes 1" beyond
the surrounding cabinets.
• Check again to be sure the unit is level.
SET TEMPERATURE
6
CONTROLS
• The temperature controls are preset. Refer to the
Temperature Control section for more information.
Allow 24 hours for temperature to stabilize.
13
13