Palazzetti IKI Manual De Instalación, Uso Y Mantenimiento página 23

14.4 RELOADING THE FUEL
To load fuel inside the machine while it is running, follow
the procedure below:
smoke to escape in the environment (based on the
Avoid overheating the stove by loading an excessive
amount of fuel.
Insert the fuel only when the grill bases are formed
The stove is provided with a bypass valve that favours
smoke transfer in the fume exhaust duct, minimizing the
smoke puffs in the environment.
14.5 ADJUSTING THE PRIMARY AIR
The stove is provided with primary air adjustment system
for combustion control.
The combustion is adjusted by inserting the provided cool
handle in the slit on the base of the door corner turning
it to right to reduce the air intake and to left to increase
14.6 ADJUSTING THE SECONDARY AIR
The stove is provided with a system that allows limiting
the soot and ash deposits on the glass and ensuring
Depending on the type of wood used, on the humidity
level and on the fume exhaust duct draught, you might
around the glass.
The combustion is adjusted by inserting the provided
cool handle in the slit between the grids on the top of the
door, turning it to right to reduce the air intake and to left
14.7 ADJUSTING THE DRAUGHT
The stove is provided with a draught adjustment valve for
The draught should be adjusted by the installer at stove
commissioning.
If the fume exhaust duct draught is optimal, leave the
valve open, if the draught is excessive close it making
sure that there are no smoke puffs in the environment if
the door is opened.
The declared nominal yield of the chimney is obtained
by burning the right quantity of wood, making sure not
to overload the combustion chamber. The ideal length of
the wood is provided by the length of the log holder.
OPEN
CLOSED
23