™
Ice 'N Water
Electronic Control
Dispenser (Some models)
OK
CHANGE
!
CAUTION
To avoid personal injury or property damage, observe
following instructions:
• Do not operate dispenser with freezer door open.
• Do not put fingers, hands, or any foreign object into
dispenser opening.
• Do not use sharp objects to break ice.
Water Dispenser Operation
It takes approximately 1 minute after initially pressing
dispenser bar before water dispenses after initial
connection of water supply. Discard first 10–14 containers
of water after initially connecting refrigerator to household
water supply and after extended periods of nonuse.
•
Dispense water by pressing sturdy wide mouthed
container against water dispenser bar.
Note: If water dispenser is active for more than 5
minutes, an automatic lock out sensor will shut down
power to dispenser area. See Automatic Lock Out for
further information.
•
Stop water dispensing by releasing pressure on bar. A
small amount of water may continue to fall. Spill shelf
is not self-draining. Large spills should be wiped dry.
Ice Dispenser Operation
!
CAUTION
To avoid property damage, do not dispense ice directly
into thin glass, fine china, or delicate crystal.
•
Select cubed or crushed mode by pushing the button
on the dispenser panel. A green indicator light above
the button indicates the current selection. Dispense
ice by pressing wide-mouthed container against ice
dispenser bar. Selection mode may not be changed
while ice dispenser is in operation.
Important
Reduce spraying of crushed ice by holding wide
mouthed container directly under ice chute and as
high as possible in dispenser area.
If dispensing ice continuously, dispenser motor is
designed to shut off after 3 to 5 minutes. Motor resets
after 3 minutes and dispensing can continue.
A slight delay occurs when switching between cubed and
crushed modes. Pieces of crushed ice will vary in size
and shape. "Snow" may form on door and ice chute when
repeatedly dispensing crushed ice. Allow "snow" to
evaporate or wipe dry.
CRUSHED
CUBED
LIGHT
SENSOR
FILTERED ICE
AUTO LIGHT DISPENSER LOCK
Taste and Odor
Observe the following to minimize taste and odor
difficulties:
• Wrap foods in tightly sealed containers or moisture
proof bags.
• Contact local water treatment company for specialized
help if difficulties persist.
• If refrigerator has a water filter replace water filter
cartridge, see Water Filtration System Installation and
Operating Instructions for replacement procedure.
Dispenser Light
A light activates at full power when dispensing ice or
water at full power. A light sensor automatically activates
light at half-power when light levels in refrigerator area are
low. Activate or deactivate sensor by pushing AUTO
LIGHT button located on control façade. A green indicator
light above the button indicates the sensor is active.
Dispenser Lock
This feature prevents operating both the water and ice
dispenser. To activate or deactivate lock, press and hold
DISPENSER LOCK button for 3 seconds. A green
indicator light above the button indicates the dispenser is
locked.
Automatic Lock Out
The automatic lock out feature shuts down the ice and
water mechanisms of the dispenser when either
mechanism has run continuously for 5 minutes. To return
power to the the dispenser, press and hold the
DISPENSER LOCK button for 3 seconds.
Filter Light
The filter indicator light serves as a reminder to replace
the water filter. A green light indicates that the filter is in
good condition. A red light indicates that the filter should
be replaced. Once the light turns red, it will remain red
until it is reset.
To reset indicator light, press both the DISPENSER
LOCK and AUTO LIGHT buttons simultaneously for 4
seconds. The green indicator light will flash 3 times when
a reset has successfully occurred.
IMPORTANT: Filter status should be reset whenever filter
is replaced.
13
FILTERED WATER