• Remove toe grille to gain access to roller
adjustment screws.
!
CAUTION
To avoid property damage and damage to the unit, do
not use power tools to adjust leveling. Use hand tools
only.
• Turn rear roller adjustment screw clockwise to raise
corner that is rocking.
A
C
A.
Rear roller adjustment screw
B.
Door hinge screws
• Check alignment of top of doors. If doors are level
replace toe grille.
If tops of doors are not level perform the following steps:
• Remove toe grille.
• Determine which door needs to be lowered.
• To lower corner of door, turn front roller adjustment
screw counterclockwise.
• Roller adjustment screw should be turned until
doors are level.
A.
Turn roller adjustment screw to lower door.
• If the unit has reached the bottom of its adjustment
range, and the doors are still not level–raise the
opposite door by turning its roller adjustment screw
clockwise.
B.
Turn roller adjustment screw to raise door.
7. Review "Installation Checklist" in
Owner's Manual with consumer.
B
C. Front roller adjustment screw
A
B
Controls
This refrigerator is designed to operate at normal
household temperatures of 55° to 110°F (13° to 43°C).
Refrigerator and Freezer Controls
Refrigerator and freezer controls are located on upper rear
wall of refrigerator section.
A
B
A.
Freezer control
B.
Refrigerator control
When freezer control is set to off , neither refrigerator nor
freezer sections will cool.
Setting Controls
With setting 1 being the warmest and setting 7 being the
coldest, start by setting both controls to 4
Adjust controls by using a household thermometer that
includes temperatures between -5° to 50°F (-21° to 10°C).
Place thermometer snugly between frozen packages in
freezer section. Wait 5 to 8 hours. If freezer temperature
is not 0° to 2°F (-17° to -16°C), adjust freezer control by
one number at a time. Check temperature again after 5 to
8 hours.
Place thermometer in a glass of water in middle of
refrigerator section. Wait 5 to 8 hours. If refrigerator
temperature is not 38° to 40°F (3° to 4°C), adjust
refrigerator control by one number at a time. Check
temperature again after 5 to 8 hours.
5
.