Start-Up; General Information; User Interface And Navigation; Keyboard And Display - Hach sensION+ EC 5 Manual De Instrucciones

4. Start-up

4.1. General information

Important note: before start-up, make sure that the sensor is connected to the measuring instrument.
1. Connect the sensor (if necessary) to the
measuring instrument (Fig. 3, pg. 7).
2. Turn on the instrument.
3. Perform calibration (see pg. 11-12).
4. Take measurement (see pg.10).
Note: With the instrument switched off,
- Press the key and the instrument
will begin measuring.
- Press the key and the instrument
will begin calibration.

4.2 User interface and navigation

4.2.1 Keyboard and display

Figure 4 indicates the instrument keys and display.
EC
1
@25ºC
@20ºC
2
TDS
Sal
3
T
4
t
8
sensION+ EC5 HACH 0710.indd ANG:8 sensION+ EC5 HACH 0710.indd ANG:8
Software version. Instrument
serial number.
μS/cm
mS/cm
mg/l
g/l
ºF
5
ºC
6
Bat
Fig. 4. Keypad descriptiont
Platinum configured Standby screen.
cell (see pg. 9)
Display
Measured conductivity/salinity/
1
TDS values.
2 Reference temperature.
3 Temperature of the sample.
4 Measuring time (hh:mm:ss).
5 Units of measurement.
6 Battery indicator.
Keypad
- Instrument on/off.
- Display light on.
- Start of measuring.
- Start of calibration.
- Selection of parameter and stan-
dard to calibrate.
- Selection of temperature units.
- Start of set-up.
7/9/10 12:50:58 7/9/10 12:50:58