Maintenance
Directions for products cleaning
! Water contains limestone in different qualities, which
remains kept on the surfaces of the product, leaving
deposits after the water has been evaporated. It is
possible to prevent the forming of limestone deposits
and to keep your product clean by drying it always
with a soft cloth immediately after use.
! Detergents, solvents, chemical agents, abrasive
sponges, wire wool, alcohol, etc. should not be
used as these could irreparably damage products'
surfaces compromising their aesthetics, brightness
and satinizing. clean only with water and neutral soap
wiping with a soft cloth.
! Clean regularly the aerator filter after having
it disassembled and after having removed the
limestone which obstructs the outlets.
! When using spray soap, splash first on a clean cloth
or on a sponge, NEVER directly on the product.
The company reserves the right to cancel the
guarantee if the above conditions are not complied
with and checked by a technician of the Company.
Disposal
Observe local environmental standards when
disposing packaging material for recycling purposes.
Cartridge replacement
Before carrying out this operation make sure that
water supply is turned off.
Remove the finish plug paying attention not to damage
it and unscrew the screw (A) to extract the handle (B).
Lift the finishing ring nut (C).
Remove the indicator ring (D), unscrew the fixing ring
nut (E) and take the cartridge (F) out from the mixer
body.
Put the new cartridge into the body checking that the
two centering pins enters into the respective seats (X)
and that gaskets are well positioned.
(Fig. 8-9)
Aerator cleaning / replacing
If the supply is not fluid unscrew manually the aerator-
holder, remove the filter without damaging and/or
loosing the gasket. If the filter is clogged just rinse
it with running water without using any detergents.
If it is damaged it can be replaced, together with a
new gasket, and they have to be reassembled in the
opposite sequence.
(Fig. 10-12)
EN
17