Protocol > Snmp; Wireless > Basic - Cisco LINKSYS Wireless-G WPSM54G Manual Del Usuario

Chapter 3
In most cases, the Gateway IP address is the IP address
of your router, and you should complete the Gateway
field if you will use the PrintServer for Internet printing .
(To find out your router's IP address, refer to your router's
documentation .)
Connection
Delay before reconnection attempt
in seconds, you want the PrintServer to wait between
attempts .
Number of reconnection attempts
of times that the PrintServer will attempt to connect to
the network .
Click the Save button to apply your changes, or click the
Cancel button to cancel your changes .
Protocol > SNMP
Use this screen to view or change the PrintServer's SNMP
(Simple Network Management Protocol) settings .
The PrintServer supports SNMP, which allows network
administrators to monitor and control the PrintServer
through the use of network management platforms, such
as HP OpenView .
The appropriate MIB file must be imported into your
SNMP management program using the Import-Compile
command . Check your program's documentation for
details on this procedure . The MIB file is named Mib2p .mib
and is provided in the MIB folder on the Setup CD-ROM .
Protocol > SNMP
General
SysContact Enter the name of the contact person .
SysLocation Enter the location of the contact person .
Wireless-G PrintServer
Set how long,
Specify the number
Advanced Configuration
Management Stations
Station No.
Select the number of the management
station (1-4) . Click the Get Data button to display the
information for the selected station .
IP Address
Enter the IP address of the management
station running the SNMP program .
Community Enter the name of the SNMP community,
which is usually public or private .
Access Select the level of access for this management
station: Not Accessible, Read-only, or Read/Write .
Trap Receivers
Receiver No.
Select the number of the trap receiver (1-4) .
Click the Get Data button to display the information for
the selected trap receiver .
IP Address Enter the IP address of the trap receiver that
will be sent the trap messages or notifications .
Community
Enter the name of the SNMP community,
which is usually public or private .
Enable with Severity level
select this option . From the drop-down menu, select the
desired level of severity, with 1 being least severe .
Click the Save button to apply your changes, or click the
Cancel button to cancel your changes .
Wireless > Basic
This screen allows you to change the PrintServer's basic
wireless settings .
Wireless > Basic
Configuration
Regulatory Domain and MAC Address
Regulatory Domain and MAC Address are listed and
cannot be changed .
SSID
Enter the name of your wireless network . This is the
unique name shared by all devices in a wireless network .
The SSID is case-sensitive and should have 32 or fewer
characters .
Channel No.
If your network is set to ad-hoc mode, select
your network's channel setting . If your network is set to
infrastructure mode, keep the default, Auto .
To designate a severity level,
The PrintServer's
7