Status > Device; Firmware Upgrade - Cisco LINKSYS Wireless-G WPSM54G Manual Del Usuario

Chapter 3
Printer > Logical Port
Select Printer
Logical Printer No.
Select the number (1-3) of the printer
you wish to configure . Click the Get Data button to update
the display with the current data for the selected logical
printer .
Details
Pre-string (Hex)
Enter the printer control string (in
hexadecimal characters) to be sent to the printer before
each print job . This string cannot exceed 30 characters .
Post String (Hex) Enter the printer control string (in
hexadecimal characters) to be sent to the printer after
each print job . This string cannot exceed 30 characters .
Convert LF to CR+LF Select this option if you want LF
(line feed) characters changed to CR+LF (carriage return
+ line feed) characters .
Click the Save button to apply your changes, or click the
Cancel button to cancel your changes .
Status > Device
The Device screen displays the current settings of the
PrintServer . No values can be changed on this screen .
Click the Refresh button to update the information on
this screen .
Server Details
Status > Device - Server Details
Wireless-G PrintServer
Advanced Configuration
Upgrade A firmware upgrade can only be performed
when the PrintServer is connected to the network using
its Ethernet port . If you want to upgrade the PrintServer's
firmware, follow these instructions:
1 . Go to the Linksys website at http://www .linksys .com .
2 . Select Support and then Download . Find your
product's name and download the latest firmware for
the PrintServer .
3 . Extract the firmware file on your PC .
4 . Unplug the power from the PrintServer .
5 . Connect an Ethernet network cable to the Ethernet
port of the PrintServer . Connect the other end of the
cable to one of the local network ports on your router .
NOTE:
To upgrade the PrintServer's firmware, it
must be physically connected to your router .
5 . Open the web browser of your PC .
6 . In the Address field, enter the IP address of the
PrintServer . (If you do not know its IP address, double-
click the PrintServer Utility icon . The IP address of
the PrintServer will be displayed on the Print Server
Information screen .)
7 . On the login screen, enter
field . Then enter the password in the Password field .
Click the OK button .
8 . Click the Status tab .
Device tab . Click the Upgrade button . You
9 . Click the
will be taken to the Firmware Upgrade screen .

Firmware Upgrade

5 . Enter the location of the firmware file or click the
Browse button to find the file .
6 . Click the Start Upgrade button, and follow the on-
screen instructions .
Status > Device - Firmware Upgrade
When you have finished upgrading the PrintServer's
firmware, follow these instructions:
1 . Unplug the power from the PrintServer .
2 . Disconnect the Ethernet network cable from the
PrintServer and router .
3 . Plug in the power to the PrintServer . It should
automatically reconnect to the wireless network .
admin in the User Name
10