Chapter 1: Product Overview; Front Panel; Back Panel - Cisco LINKSYS Wireless-G WPSM54G Manual Del Usuario

Chapter 1
Chapter 1:
Product Overview
Thank you for choosing the Linksys Wireless-G PrintServer .
The PrintServer lets you connect a USB printer directly
to your network, so your networked computers can
share a single printer . It is compatible with most USB
multifunction printers, and it allows full access to printing,
faxing, scanning, and copying functions . Like any print
server, users on the network can print anytime . The other
functions are treated a little differently—any user can
request access to one of the other functions and get
exclusive use of that function until the task is complete .

Front Panel

USB (Green/Orange) The USB LED lights up
green when there is a printer connected to the
USB port . It flashes green when the PrintServer
is sending data through the USB port . The LED
lights up orange when there is a problem with
the printer .
Wireless
(Green) The Wireless LED lights up
when there is a wireless connection . It flashes
when the PrintServer is sending or receiving
data over the wireless network .
Ethernet
(Green/Orange)
LED lights up green when the PrintServer is
connected to a device through the Ethernet
port . It flashes green when the PrintServer is
sending or receiving data over that port . It
flashes orange when collisions are detected on
the Ethernet port .
Power (Green/Orange) The Power LED lights
up green when the PrintServer is ready for use .
It flashes green when the PrintServer is booting
up, a system self-test is running, or the firmware
is being upgraded . The LED lights up orange
when there is an error .
Wireless-G PrintServer
The Ethernet

Back Panel

Reset The Reset button can be used to restore
the PrintServer's factory default settings or
print a test page .
Reset to Factory Defaults
Hold down the Reset button for ten seconds,
and the PrintServer will be reset to its factory
default settings .
NOTE:
Resetting the PrintServer will
delete all of your custom settings
and replace them with the factory
defaults . Do not reset the PrintServer
if you want to retain your settings .
Print a Test Page
1 . Make sure that both the PrintServer and
the printer connected to the USB port are
powered on .
2 . Press the Reset button, and hold it down for
two seconds .
3 . The test page, which lists the current settings
of the PrintServer, will be printed .
NOTE: PostScript printers are unable
to print this test page . If you have a
PostScript printer on the USB port, the
test page will not be printed .
Ethernet
The Ethernet port connects the
PrintServer to your wired network for setup .
USB The USB port connects the PrintServer to
the USB printer .
Power
The Power port connects the PrintServer
to the power adapter .
Product Overview
2