Sterling 5900SP Guía De Instalación Y Cuidado página 7

Puertas corredizas de bañera y ducha
Tabla de contenido

Publicidad

1.
Prepare the Bottom Track
Measure here.
Mesurer ici.
Mida aquí.
Curved Base
Base courbée
Base curva
CAUTION: Risk of personal injury. Always wear safety glasses when cutting
materials.
IMPORTANT! If your shower has a curve in the corners where they meet the
sidewalls, be sure to measure from wall to wall above the curves. Failure to measure
above the curve or angle could result in the bottom track being cut too short.
IMPORTANT! This bypass bath/shower door includes two sets of wall jambs,
tapered and non-tapered. If you are installing the door to a Sterling Advantage
bath/shower unit or a unit with a taper in the lower wall, use the tapered set. For all
other bath units, use the non-tapered set. Discard the unused set.
Measure from wall to wall at the flattest part of the shower ledge (dimension "D").
Mark dimension "D" on the bottom track.
IMPORTANT! For best results, use a 32-teeth per inch hacksaw blade and a miter
box to cut the bottom track.
For tapered wall jambs: subtract 1-1/8" (2.9 cm) from dimension "D", then cut
the bottom track to this dimension.
For non-tapered wall jambs: subtract 1/4" (6 mm) from dimension "D" , then cut
the bottom track to this dimension.
File the rough edges smooth where the bottom track was cut, taking care not to
mar the finished surface.
NOTE: If there are curves where the sidewalls meet the threshold, use a file to
contour the bottom track edges to match the curves.
Préparer le rail inférieur
ATTENTION: Risque de blessures corporelles. Porter des lunettes de protection
lors de la découpe des matériaux.
IMPORTANT! Si la baignoire à des coins arrondis, veiller à mesurer d'un mur à
l'autre au-dessus des coins, sinon, le rail inférieur risquerait d'être trop court.
Sterling
Measure distance "D"
above curves in the
corners.
Mesurer la distance "D"
au-dessus des courbes
des angles.
Mida la distancia "D" por
encima de las curvas en
las esquinas.
D
7
Measure here.
Mesurer ici.
Mida aquí.
Angled Base
Base inclinée
Base en ángulo
1063220-2-G

Publicidad

Tabla de contenido
loading

Tabla de contenido