In order to carry out a proper installation of the operator, it is necessary to comply with the geometry measurement shown in the tables in Pic. 6 and 8.
X
D
ASSEMBLING DRIVE ARM WITH THE ANTI-
THEFT LOCKING DEVICE (E)
Assemble the arms as shown in Pic. 5.
Caution: Once the screws V and W have been thoroughly
tightened (Pic. 5) unscrew them for half a turn, in order to
guarantee a free movement of the arm.
After assembling the arm, unlock the motor and fix the arm
to the motor with the supplied screw and M10 washer.
With the gate in closing position and the motor at rest, the
anti-theft lock (E) keeps the gate leaves securely closed
and prevents anybody from forcing the gate leaves open.
FIXING THE DRIVE ARM WITH THE ANTI-THEFT LOCKING DEVICE (E)
Unlock the operator.
Caution: start the operation with the gate in closing position. Straighten the levers until the anti-theft lock (E Pic. 5) is engaged and stressed. Move the
levers back a little bit just enough to avoid keeping the anti-theft locking in working position (stressed) every time the gate will close.