Introduction; Index; System Characteristics - golmar SAR-2PLUS Manual De Instalación

INTRODUCTION

First of all we would like to thank and congratulate you for the purchase of this product manufactured by
Golmar.
The commitment to reach the satisfaction of our customers is stated through the ISO-9001 certification
and for the manufacturing of products like this one.
Its advanced technology and exacting quality control will do that customers and users enjoy with the
legion of features this system offers. To obtain the maximum profit of these features and a properly wired
installation, we kindly recommend you to expend a few minutes of your time to read this manual.

INDEX

Introduction ...........................................33
Index.....................................................33
System characteristics ..............................33
Safety precautions...................................34
Operation modes .......................................
Relay for additional call repeater.............35
Relay for Lock release ............................35
Bus relay .............................................36
Description ............................................37
Installation.................................................
Detail of relay unit installation.................37
Configuration of relay unit .....................38
System selection jumper ........................38
Adjustment potentiometer......................39
Programming Led .................................39
End of line (only V2Plus system)...............39

SYSTEM CHARACTERISTICS

Digital relay for 2PLUS and V2PLUS systems, which permits the following operation modes:
Relay for additional call repeater.
Relay for 2nd door Lock release.
Bus relay.
Need to configure or program depending on the mode of operation.
Can be installed at any point of installation (see operation modes).
It connects directly to the bus as another element of the installation.
Easily configurable through easy access microswitch.
Programming status led.
Jumper JP1 selects whether the relay is connected to a 2PLUS or V2PLUS system.
Potentiometer PT1 sets the relay operating time.
The maximum current for relay contact will be of 1.8A at 30 Vdc/250 Vac.
The minimum wire section to connect in the relay outputs will be 1.5 mm .
The product includes a fuse of 250V 2A F . Compliance with EN60127-1/EN60127-2 Standards.
The product includes a 120 ohm resistor for End of line (only V2Plus system).
Use Golmar wire RAP-2150 for bus connection to V2PLUS system.
Programming .............................................
Additional call repeater .........................40
Configuration (2Plus system) ........................
Additional call repeater .........................41
Bus relay .............................................41
Relay for Lock release ............................42
Configuration (V2Plus system) ......................
Additional call repeater .........................43
Bus relay .............................................43
Relay for Lock release ............................44
Installation diagrams...................................
Relay unit (2Plus system) ........................45
Relay unit (V2Plus system) ......................46
Troubleshooting hints ..............................47
Notes...............................................48-50
Compliance...........................................51
33
2