Additional Call Repeater - golmar SAR-2PLUS Manual De Instalación

40
2Plus system:
To program the relay unit as additional call repeater, follow these steps:
Phone must be programmed in advance (see T2PlusML document).
Set SW1-1 to ON.
Programming led is OFF .
Set SW1-3 to ON, to enter programming mode.
Programming led is Blinking.
Make a call to verify that the relay unit has been sucessfully programmed. If
V2Plus system:
To program the relay unit as additional call repeater, follow these steps:
Monitor/Phone must be programmed in advance (see TV2PlusML document).
Set SW1-1 to ON.
programming led is OFF .
Set SW1-3 to ON, to enter programming mode.
Programming led is Blinking.
Make a call to verify that the relay unit has been sucessfully programmed. If
Pick the handset up of the phone associated with the relay unit
and push door release button.
The programming led will be set to ON indicating that the
relay unit has been programmed.
Hang up the hanset of the phone and set SW1-3 to OFF .
The programming led will be set to OFF indicating that the
programming mode is complete.
there are more relay units to use as additional call repeater, program them in
the same way.
Pick the handset up of the monitor/phone associated with the
relay unit and push door release button.
The programming led will be set to ON indicating that the
relay unit has been programmed.
Hang up the hanset of the monitor/phone and set SW1-3 to
OFF.
The programming led will be set to OFF indicating that the
programming mode is complete.
there are more relay units to use as additional call repeater, program them in
the same way.
PROGRAMMING
A
dditional call repeater.