Tetratec EX 400 Manual De Instrucciones página 18

1
Filling with Filter Media
1
2
3
Filling with Filter Media
For EX 400 / 600:
Bottom Tray: Tetratec
Second Tray: Tetratec
Third Tray: Tetratec
then Tetratec
For EX 700 / 1200 / 2400:
Bottom Tray: Tetratec
Second Tray: Tetratec
Third Tray: Tetratec
Fourth Tray: Tetratec
(2 units for EX 1200 / 2400), then Tetratec
4
18
Set up
Remove the motor head from the filter case of the Tetratec
Filter. To release the motor head, lift the locking buckles with the
Tetratec ®
Release the lift buckles to slightly raise the motor head from the
filter case.
Lift
buckles
Remove the motor head by lifting one of the lift buckles while
holding down the filter case frame.
Remove the filter media securing plate and filter media containers
from the filter case.
Clean all the Filter Media
Take out all of the filter media from the filter media containers and
rinse them in water. Take the filter media out of the plastic bags
before use.
After rinsing, return to the filter media containers as per the
original order. (The placement is shown below.)
® CR Ceramic Rings and on top Tetratec
® BB Bio Filter Balls (except EX 400)
® BF Biological Filter Foam, then Tetratec
® FF Filter Floss Pad
® CR Ceramic Rings and on top Tetratec
® BB Bio Filter Balls
® BF Biological Filter Medium (2 units)
® BF Biological Filter Foam, then Tetratec
Important: Reset all filter media containers and the filter media
securing plate so that the "
align with the "
logo.
® BF Biological Filter Foam
® CF Carbon Filter Medium,
® BF Biological Filter Foam
® CF Carbon Filter Medium
® FF Filter Floss Pad
" marks on the handle of the containers
" marks on the filter case.
® EX