I.SOUND DreamTime Pro Guía De Usuario página 5

seconds the display will stop ashing to indicate the time is set.
DST (Daylight Saving Time) se ing
Switch DST to +1 or -1 to automatically adjust for Daylight
Savings Time.
Install backup clock ba ery
Installing/replacing backup ba eries
1. Make sure the DC adapter is connected to the wall,
otherwise the time may be lost during ba ery replacement.
2. Open the ba ery compartment cover located on the
bo om of the unit.
3. Insert two "AA" ba eries, checking that the positive
polarity follows the direction of the instructions inside the
ba ery compartment.
4. Close the compartment cover
NOTE: Ba eries must be installed in order for time and alarm
memory back-up to operate. In the event of power failure or
disconnection, if the ba ery is not installed, the clock and
alarm will need to be reset when power is restored.
Ba ery precautions
1. Use only the size and type of ba eries speci ed.
2. When installing ba eries, observe proper +/- polarities.
Incorrect installation of ba ery may cause damage to the unit.
3. Do no mix di erent types of ba eries together (ie: alkaline
with carbon-zinc or old ba eries with new ones).
4. If the unit is not going to be used for a long period of time,
remove the ba eries to prevent damage due to possible
ba ery leakage.
5. Do not dispose of the ba eries in a re. Ba eries may
explode or leak.