Descargar Imprimir esta página

Altec Lansing PT6021 Guia Del Usuario página 7

Publicidad

Idiomas disponibles

Idiomas disponibles

Symptom
Possible Problem
No sound
Subwoofer volume set too low.
from subwoofer.
Sound source has little low-frequency content.
Low hum
The AC in your house is at 60 cycles per second, which is
from subwoofer.
within the audio frequency of the subwoofer.
Loud hum
Bad connection.
from subwoofer.
Volume on your audio source device set too high.
Not enough bass
Bass setting is too low.
from subwoofer.
Bad connection.
Too much bass
Bass setting is too high.
from subwoofer.
Distorted
Subwoofer too close to monitor/TV.
monitor/TV.
Wireless speaker
Battery may be dead.
system remote
does not work.
Satellite base
Tighten base.
is loose.
Solution
Adjust the bass level on the wired controller or wireless speaker system remote.
Try a game, movie or song — anything with more prominent bass tones.
Some low hum may be detected when your speaker system is powered on
without an audio source playing, or when the volume is set at an extremely
low level.
If you are using a surge protector with your PT6021 speaker system, disconnect
and plug the power adapter directly into an AC wall outlet.
Move your cables. Check to ensure they are making a clear connection.
Disconnect your stereo cable from the audio source. If the loud hum goes away,
lower the volume on the audio source.
Adjust the bass level on the wired controller or wireless speaker system remote.
Verify that all cables are connected properly and are making a clear connection.
Decrease the bass level on the wired controller or wireless speaker system
remote.
Because the subwoofer IS NOT magnetically shielded, it may cause distortion
if it is placed too close to your monitor/TV. Move the subwoofer so it's at least
2 feet from your monitor/TV.
Replace the wireless speaker system remote battery with a CR2025 or
equivalent.
Use a standard Phillips-head screwdriver to tighten the two screws located on
the rear of each set.
5

Publicidad

loading