MRA KBA 90512 Instrucciones De Montaje página 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA screen
4 Spacers, 6 mm
4 O-rings, 4.5x1.5 mm
4 Oval head screws, M5x30 mm
4 Caps, black
4 Cap rings, M5, white
1 Edge protection strip with end sleeves
How to mount the screen on your scooter:
1. Stand your scooter up on a level surface.
2. Dismantle the original screen.
3. Insert the M5x25 mm oval head screws supplied through the white cap rings. Make
sure that the cap ring cones point towards the screw heads.
4. Insert the screws with the cap rings through the MRA screen, and the 6 mm spacers
with the O-rings against the screws from the rear (the inner surface of the screen)
(P1).
5. Mount the MRA screen onto your scooter. Align the screen to the centre and tighten
the screws.
6. Finally, place the black caps supplied onto the white cap rings.
7. Mount the edge protector strip; slide the end sleeves over the ends of the edge
protector strip and gently crimp the sleeves with a pair of pliers to secure it (P2).
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
YAMAHA NMAX 125 16-
Article No..
--- Phillips screwdriver
11038
10992
10693
10876
10877
---
3
Required tools