Setting Up The Miniox ® 3000 Oxygen Monitor - Ohio Medical Corporation MiniOX 3000 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

MiniOX
3000 Oxygen Monitor
®
Section 2
Setting Up the MiniOX
Oxygen Monitor
The MiniOX
3000 Oxygen Monitor is packaged in
®
a shipping carton suitable for instrument storage. If
there is obvious damage to the shipping carton or its
contents, contact Ohio Medical Corporation Repair at:
1-847-855-0800
To set up the monitor:
1. Verify that you have the following (see Figure
2-1):
MiniOX
3000 Oxygen Monitor
®
Oxygen sensor and deflector in sealed
package
10-foot coiled cable with twist collar.
Tee adapter
SENSOR
RETAINING STRAP
3000
®
MINIOX
OXYGEN MONITOR
TEE
ADAPTER
Figure 2-1
MiniOX
3000 Oxygen Monitor
®
711449 (Rev.3) 02/2016
Section 2, Setting up the MiniOX
Sensor retaining strap
9-volt alkaline battery
MiniOX
3000 Operation Manual CD
®
2. Check the sensor's manufacturing date on the
sensor package. If the sensor is put into service
within six months after this date, the sensor will
meet performance specifications.
3.
Remove the sensor from the sealed package
and attach it to the coiled cable.
a. Firmly press the connector until it snaps
into place; tighten the twist collar.
b. Insert the opposite end of the coiled cable
into the jack on the side panel of the
instrument; tighten the twist collar.
4. Remove the deflector from the package.
a. Insert the gasket into the open end of
the deflector, ensuring that the gasket is
properly seated within the deflector.
OXYGEN SENSOR AND DEFLECTOR
IN SEALED CONTAINER
3000
®
3000 Oxygen Monitor
®
9-VOLT
ALKALINE
BATTERY
TWIST
COLLAR
COILED
CABLE
2-1

Publicidad

Tabla de contenido
loading

Tabla de contenido