CLEANING & MAINTENANCE
Attention! Ensure that the device is switched off during any measures and
!
the power plug is disconnected from the mains socket.
Display
8
WATER
9
SERVICE
8
Measures
Remove upper housing. Fill water tray in lower housing with
tap water up to maximum level indicated by the WATERLINE
marker. Place upper housing onto lower housing and switch
appliance on again.
i
As soon as there is not enough water in the water tray, the appliance
switches off automatically, LED 7 flashes continuously, and the
WATER indicator appears on the display. In the humidity indicator 2,
two dashes flash and the ambient humidity is not displayed.
In order to continuously humidify the ambient air and reduce harmful
substances (particles down to 10 µm), we recommend topping up the
water daily.
Remove upper housing. Empty the residual water out of the wa-
ter tray. Rinse out water tray and evaporation unit thoroughly.
Fill water tray in lower housing with tap water up to maximum
level indicated by the WATERLINE marker. Reassemble appli-
ance and switch it on. Touch SERVICE indicator 9 on the display
and hold for approx. 3 seconds until it goes out.
i
For perfectly hygienic constant operation, the SERVICE indicator
reminds you to carry out servicing every 14 days (also in standby
mode).
11
10
9
EN
31