Skil F012 3710 Serie Manual Original página 27

Maximum Workpiece Dimensions [mm]
F0123710AA
Miter Angle
Workpiece
Form
0 °
125 Ø
115 x 115 95 x 95
110 x 130 100 x 95 60 x 120
137 x 137 100 x 100
F0123710AB/JA/JB/JC
Miter Angle
45 ° 0 °
115 Ø 72 Ø 72 Ø
65 x 65 60 x 60
60 x 70
90 x90 85 x 85
Adjusting the Depth Stop
(see figure E)
In the delivery condition of the machine, the depth stop
4 is adjusted in such a manner that a new
45 °
355mm cutting disc does not touch the base plate
when cutting.
To compensate the wear of the cutting disc, the depth
stop can be set deeper.
When using a new cutting disc, the depth stop must
then always be set back to the original position.
Always adjust the depth stop in such a manner
X
that the cutting disc does not touch the base
plate when cutting.
– Place the machine in the working position. (see
"Releasing the Machine (Working Position)",
page10)
– Loosen the lock nut
(size 13mm) provided.
– Swing the tool arm with the handle
requested position.
– Screw the depth stop
counterclockwise direction until the screw head
touches the housing.
– Slowly guide the tool arm upward and tighten the
lock nut 5.
27
5 with the box-end wrench 8
1 to the
4 in clockwise or