Hunter Halcyon El Manual Del Propietario página 15

Existing Construction – accessible only from below
D11
EXISTING FAN
Remove an existing fan and check to make sure the
opening is large enough to accommodate the new
motor housing (8"x 8.5").
D13
Pull wires through strain relief
D15
E
Install the housing flush with the sheetrock and secure
by tightening the pre-loaded screws into the joist.
D12
Move the housing into position above the ceiling.
D14
. Attach existing ducting to duct connector. Tape joints.
an adapter may need to be purchased.
15
43034-01 12/01/2013
E
If ducting does not fit securely,