Rs232 Interface Cable To Td52Xw; Micro Sd Card Installation - OHAUS Defender 5000 Serie Manual De Instrucciones

EN-12 Defender 5000 Indicators
After wiring is completed, replace the indicator housing screws. Make sure the liquid-tight connector
is properly tightened.

2.3.3 RS232 Interface Cable to TD52XW

Pass the optional RS232 cable through the strain relief (Figure 1-2, item 10) and attach it to terminal
block J5 (Figure 1-3, item 7). Tighten the strain relief to maintain a watertight seal.

2.3.4 MICRO SD Card Installation

The SD memory card can be used for additional storage in the Checkweighing and Counting
applications. Figure 2-5 shows the installation of an SD card into the socket on the edge of the TD52P
and TD52XW main boards.
Figure 2-5 Sliding an SD Card into the SD Socket (left); SD Card Installed (right)