DSC IMPASSA TL8055LT Manual De Instalación página 16

Alarm.com LTE
Menu
Installer
Programming
--Number of Z-Wave
2
Devices
---Add Z-Wave Device
---Remove Z-Wave Device
---Z-Wave Home ID2
---Image Sensor Setup1
1
---Learn Image Sensor
1
---Delete Image Sensor
---Image Sensor Settings
1
----Image Sensor #[x]
-----[Power Information]
1
-----Signal
1
-----Test PIR
1
-----PIR Sensitivity
1
-----Rules
1
-----MAC
1
-----Version
1
-----Last Talk
---Extended Range Option
---Communications Test
User Functions
--LTE Module Status
---Radio
---LTE Freq.
--SN
---SIM card
---Version
---Advanced - Network
2
--Z-Wave Setup
---Number of Z-Wave
2
Devices
---Add Z-Wave Device
---Remove Z-Wave Device
2
---Z-Wave Home ID
1
--Image Sensor Setup
1
---Image Sensor #[x]
----[Power Information]
1
----Signal
Description
Press [*][8] [Installer Code] [851] to enter Interactive Services menu
The total number of Z-Wave devices currently known to the HSPA module
2
Press [*] to enter Z-Wave Add Mode. Make sure the device being added is powered up
and within 3 to 6 feet of the IMPASSA panel. Refer to the manufacturer's instructions
for button presses required to enroll devices
2
Press [*] to remove an existing Z-Wave device, or to "reset" a Z-Wave device that was
previously learned into a different Z-Wave network. Previously enrolled devices must
be reset before they can be enrolled into the module
Press [*] to query the Z-Wave network Home ID. If the ID is 0, verify that the module
has communicated with Alarm.com and that the Alarm.com account is set up for Z-
Wave.
An image sensor daughterboard is required to enable image sensor capabilities on the
module. This menu is only active if an image sensor daughterboard is connected
Press [*] to enter Add Mode. Enroll the image sensor by inserting batteries or resetting
Press [*] and scroll to the image sensor to delete. Press [*] to delete
1
Press [*] and scroll to the image sensor of interest. Press [*]
[x] is the sensor ID. Press [*] to view information on this image sensor.
1
Gives information on the image sensor's battery level and power status
Signal strength of the communication between image sensor and image sensor
daughterboard
Press [*] to put the image sensor in PIR Test Mode
Press [*] to view current selection. Scroll down to view sensitivity levels. Press [*] to
select
Displays whether rules are confirmed
MAC address of image sensor
Image sensor daughterboard version
Last image sensor talk time
Press [*] to enable/disable extended range
Press [*] to perform ADC communication test
Press [*] [6] [Master Access Code] to enter User Functions menu. Then scroll to
Interactive Services
See Installer Programming section
See Installer Programming section
See Installer Programming section
See Installer Programming section
See Installer Programming section
See Installer Programming section
See Installer Programming section
See Installer Programming section
See Installer Programming section
2
See Installer Programming section
2
See Installer Programming section
See Installer Programming section
See Installer Programming section
See Installer Programming section
1
See Installer Programming section
See Installer Programming section
- 14 -