Battery Replacement - Nice HSDIM24 Instrucciones Y Advertencias Para La Instalación Y El Uso

Table 4
LED
Green
Orange
Red
BUZZER
1 Beep
3+3 Beeps
5 Beeps

4 - BATTERY REPLACEMENT

Caution! – Never use battery types different from the specified version. The bat-
teries must be replaced all together (with new ones). Do not combne batteries of
different brands or models. Do not use rechargeable batteries.
Caution! – Before releasing the detector from the mounting bracket, the control
unit must be set to "CONTROL UNIT TEST" mode to avoid improper tampering
alarm signals.
01. To release the detector from the mounting bracket, use the special attachment lever
(fig. 5).
02. Slide the detector upwards by approx. 5 mm to move it away from the mounting
bracket (fig. 5).
03. Open the battery compartment as shown in fig. 7 and replace the batteries. Observe
the specified polarity.
04. Close the battery compartment and attach HSDIM24 to its mounting bracket (fig. 5).
5 - DISPOSAL
Disposal of the product
All devices in the alarm system are an integral part of the installation and must be disposed
of as a whole. As in installation operations, at the end of the products' lifespan, decommis-
sioning operations must be performed by qualified personnel.
These products are made of various types of materials: some of them can be recycled,
while others must be disposed of. Find out about recycling and disposal systems in use in
your area for this product category.
Caution! – Some parts of the products may contain polluting or hazardous substances
6
Function
Infrared sensor detection (PIR = OK)
Intrusion delay in progress (MW = ?)
Intrusion alarm (PIR+MW = OK)
Function
Alarm signal (Intrusion, Tampering)
Sensor programming (battery insertion)
Low battery signal