Snapper 2650 PSI Instrucciones De Uso página 13

SNAPPER To
SPECiFiCATiONS
Outlet Pressure ......................... 2650 psi
Flow Rate .............. 2.5 gallons per minute (gpm)
Detergent Use detergent approved for pressure washers
Water Supply ................ Not to Exceed 100°F
Temperature
Automatic Cool ............. Will cycle when water
Down System reaches 125°. 155°F
ShippingWeight ........................... 78 Ibs.
GENERAL MAINTENANCE
RECOMMENDATIONS
The pressure washer warranty does not cover items that
have been subjected to operator abuse or negligence.To
receive full value from the warranty, the operator must
maintain the pressure washer as instructed in this manual.
NOTE: Should you have questions about replacing
components on your Snapper pressure washer, please call
1=800=317=7833 for assistance.
• Some adjustments will need to be made periodically to
properly maintain your pressure washer.
• All maintenance in this manual and the engine user's
manual should be made at beast once each season.
• Once a year you should clean or replace the spark plug,
clean or replace the air filter and check the spray gun and
adjustable nozzle extension assembly for wear.A new spark
plug and clean air filter assure proper fuel-air mixture and
help your engine run better and last longer. Please refer to
your engine user's manual for more details.
• if equipped with inflatable tires, keep the air pressure at
the value marked on the tire or within 15 and 40 psi.
Before
I. Check
2. Check
3. Check
4. Check
5. Check
6. Check
leaks.
Each Use
engineoillevel.
water inlet screen for damage.
in-line filter for damage.
high pressure hose for leaks.
chemical injection hose and filter for damage.
spray gun and nozzle extension assembly for
7. Rinse out garden hose to flush out debris.
PRESSURE WASHER
MAINTENANCE
Check
and Clean Inlet
Screen
Examine the screen on the water inlet. Clean it if the
screen is clogged or replace it if screen is damaged.
Check High Pressure Hose
The high pressure hose can develop leaks from wear,
kinking, or abuse. Inspect the hose each time before using
it. Check for cuts, leaks, abrasions or bulging of cover,
damage or movement of couplings. If any of these
conditions exist, replace the hose immediately.
WARNING
NEVER repair high pressure hose. Replace it.
Replacement hose rating fflUST exceed maximum pressure
rating of unit.
Check Chemical Injection Hose
Examine the filter on the detergent tube and clean if
clogged.The tube should fit tightly on the barbed fitting.
Examine the tube for leaks or tears. Replace the filter or
tube if either is damaged.
Check Gun and Nozzle Extension
Examine the hose connection to the spray gun and make
sure it is secure.Test the trigger by squeezing it and making
sure it"springs back" into place when you release it. Put
the trigger lock in the ON position and test the trigger.
You should not be able to squeeze the trigger.
Check In-Line Filter
Refer to Figure 13 and service the in-line filter if it
becomes dogged, as follows:
Nozzle Extension
O-rin