Pressure Washer - Snapper 2650 PSI Instrucciones De Uso

HOW TO USE YOUR
PRESSURE WASHER
If you have any problems operating your pressure washer,
please call the pressure washer helpline at 1-800-317-7833.
Pressure Washer Location
Pressure Washer Clearance
WARNING
. Operate pressure washer ONLY outdoors.
. Keep exhaust gas from entering a confined area through
windows, doors, ventilation intakes or other openings.
. DO NOT operate pressure washer inside any building or
enclosure, even if doors or windows are open.
The pressure washer must be at least 5 ft. (I 52 cm) from
structures having combustible walls and/or other
combustible materials. Leave at least 3 ft. (92 cm) all around
pressure washer including overhead, for adequate cooling,
maintenance and servicing.
Place pressure washer in a well ventilated area, which will
allow for removal of deadly exhaust gas. DO NOT place
pressure washer where exhaust gas could accumulate and
enter inside or be drawn into a potentially occupied
building. Ensure exhaust gas is kept away from any
windows, doors, ventilation intakes or other openings that
can allow exhaust gas to collect in a confined area
(Figure 7). Prevailing winds and air currents should be taken
into consideration when positioning pressure washer.
Typical Pressure Washer Shown
Exhaust Port
How to Start Pressure Washer
To start your pressurewasher forthe first t ime,follow
these instructions step=by=step.This starting information
also applies if you have let the pressure washer sit idle for
at least a day.
1. Place pressure washer near an outside water source
capable of supplying water at a flow rate greater than
3.5 gallons per minute and no less than 20 PSI at
pressure washer end of garden hose.
2. Check that high pressure hose is tightly connected to
spray gun and pump. See "Preparing Pressure Washer
for Use" for illustrations.
3. Make sure unit is in level position.
4. Connect garden hose to water inlet on pressure
washer pump, Turn
ON
water.
CAUTION
Damage to equipment resulting from failure to follow this
instruction will void warranty.
S. Squeeze spray gun trigger until a steady stream of
water occurs.
6. Attach nozzle extension to spray gun (Figure 8).
Tighten by hand.
7. Place colored quick connect spray tips in slots on
holder that's attached to nozzle extension (Figure 9).
8. Choose spray tip you want to use and insert it into
nozzle extension. See "How to Use Spray Tips".