Installing A Wireless Client For Wpa; Configuring A Wireless Client For Wep; Configuring A Wireless Client With The Network Name (Ssid); La Instalación De Un Cliente Inalámbrico Para Wpa - Motorola SURFboard Guia Del Usuario

You may need to do the following to use a wireless client computer to access the Internet:
IF YOU:
Configured WPA on the gateway
Configured WEP on the gateway
Configured the Wireless Network Name on the
gateway
Configured a MAC Access Control List on the
gateway

Installing a Wireless Client for WPA

If you enabled WPA and set a PSK Passphrase by configuring WPA on the gateway, you must configure the same passphrase (key) on each
wireless client. The gateway cannot authenticate a client, if:
•
WPA is enabled on the gateway but not on the client
•
The client passphrase does not match the SVG1202 PSK Passphrase
Never provide the PSK Passphrase to anyone who is not authorized to use your WLAN.

Configuring a Wireless Client for WEP

If you enabled WEP and set a key by configuring WEP on the gateway, you must configure the same WEP key on each wireless client. The
gateway cannot authenticate a client, if:
•
Shared Key Authentication is enabled on the gateway, but not on the client
•
The client WEP key does not match the SVG1202 WEP key
For all wireless adapters, you must enter the 64-bit or 128-bit WEP key generated by the gateway.
Never provide the WEP key to anyone who is not authorized to use your WLAN.

Configuring a Wireless Client with the Network Name (SSID)

After you specify the network name on the Wireless Basic Page, many wireless cards or adapters automatically scan for an access point,
such as the gateway and the proper channel and data rate. If your card requires you to manually start scanning for an access point, follow
the instructions in the documentation supplied with the card. You must enter the same SSID in the wireless configuration setup for the
device to communicate with the gateway.
SVG1202 Wireless Voice Gateway • User Guide
Configuring Wireless Clients
YOU NEED TO DO THIS ON EACH CLIENT,:
Configure a Wireless Client for WPA or WPA2
Configure a Wireless Client for WEP
Configure a Wireless Client with the Network Name (SSID)
No client configuration required
B
43